Overlapping Corrugated Roof Sheets

The sheets should overlap by at least four inches add a bead of caulk where they overlap and at the other end of the building ensure there s an overhang of two inches.

Overlapping corrugated roof sheets.

End laps if end laps are required you should allow 300mm minimum overlap sealed with butyl sealant tape 10mm from the edge of each overlapping sheet as well as in the middle of the overlap. Learn how much to overlap the corrugated sheeting. To install corrugated roofing start by cutting your panels to length with an angle grinder. When joining panels you should use silicone sealant along their vertical length and overlap the sheets by one corrugation.

A cat ladder or roof board should always be used when working on a roof for safety of the person and to avoid damage to the roofing material. Important due to the nature of the overlap detail we would highly recommend the use of butyl sealant when using brit tile sheets. Installation of corrugated roof sheeting. It is usual to allow roof sheets to overlap into gutters by about 50 mm.

These notes are intended to cover the use and installation of corrugated roof sheets such as pvc other plastics and bitumen fibre sheets. For maximum weather tightness start laying sheets from the end of the building that will be in the lee of the worst anticipated or prevailing weather. Installing corrugated metal roofing will require you to lap the m. Whether you re working with tin roofing sheets performing corrugated roof sheeting installation or handling a different metal material working with metal means an increased probability of being cut especially when working with power tools.

Wear thick gloves when working with the metal roofing sheets and keep safety goggles on at all times. How to overlap corrugated metal roofing. Next pre drill holes on the end and side ridges of the panels spacing the holes 6 to 8 inches apart. This helps to prevent water infiltration.

A basic rule of thumb for installing metal roofing is that the piece of roofing higher up on the slope should always overlap the one below it. Strong winds can separate the overlapping edges of the panels and allow the roof to leak. Once the first sheet is in place you need to install the remainder of the lowest row of corrugated metal roofing. Beginning at the outside edge of your roof place each panel directly onto the purlins that are attached to the roof trusses.

Because of this you should start at the lowest part of the slope and work upward. Use special roofing fasteners rather than standard screws to secure the corrugated sheets as they have a waterproof seal underneath the head that prevents leaks.